The barbell row is the pulling partner to the bench press, and the easiest lift in the gym to cheat. With enough hip drive almost anyone can heave a heavy bar to their belly, which is why posted row numbers vary so wildly. An untrained man rows around four tenths of his bodyweight strictly; a year or two of consistent training usually brings that close to bodyweight.
The standards below are for a strict bent-over row: torso at about 45 degrees or flatter, the bar pulled to the lower chest or upper stomach, and no standing up to start the rep. They are written as multiples of bodyweight across five training levels for men and women, then converted into kilograms and pounds at common bodyweights.
Standards at a glance#
Each level is a one-rep max expressed as a multiple of bodyweight. Find your level in this table, then use the tables below it for the number at your weight.
| Level | Men (× bodyweight) | Women (× bodyweight) |
|---|---|---|
| Beginner | 0.4× | 0.25× |
| Novice | 0.6× | 0.4× |
| Intermediate | 0.85× | 0.6× |
| Advanced | 1.15× | 0.8× |
| Elite | 1.45× | 1.05× |
What each level means#
Beginner#
A light bar rowed with a flat back and a torso that stays still. Most of the work at this stage is learning to hold the hinge position while the arms and back do the pulling.
Novice#
About six tenths of bodyweight for a man. A few months of rowing twice a week gets most people here, and the weight goes up steadily as long as the torso angle stays honest.
Intermediate#
Around 85% of bodyweight for a man and 60% for a woman. One to two years of consistent training usually gets you here, and the row should now be close to your bench press.
Advanced#
More than bodyweight rowed strictly. Your lower back and grip become real limits, and most lifters at this level row heavy once a week and use lighter variations for volume.
Elite#
Close to one and a half times bodyweight without standing up or bouncing the bar off your hips. Very few lifters reach this with strict form.
Men's barbell row standards by bodyweight#
Every cell is a one-rep max, rounded to the nearest 2.5 kg or 5 lbs. Find the row closest to your bodyweight and read across.
Average barbell row for men#
A man at 80 kg (175 lbs) with a year or two of consistent training can expect a one-rep max around 67.5 kg (150 lbs) on the barbell row — the intermediate standard. A beginner at the same bodyweight starts near 32.5 kg (70 lbs), and an advanced lifter reaches about 92.5 kg (200 lbs).
In kilograms#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 60 kg | 25 kg | 35 kg | 50 kg | 70 kg | 87.5 kg |
| 70 kg | 27.5 kg | 42.5 kg | 60 kg | 80 kg | 102.5 kg |
| 80 kg | 32.5 kg | 47.5 kg | 67.5 kg | 92.5 kg | 115 kg |
| 90 kg | 35 kg | 55 kg | 77.5 kg | 102.5 kg | 130 kg |
| 100 kg | 40 kg | 60 kg | 85 kg | 115 kg | 145 kg |
| 110 kg | 45 kg | 65 kg | 92.5 kg | 127.5 kg | 160 kg |
In pounds#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 130 lbs | 50 lbs | 80 lbs | 110 lbs | 150 lbs | 190 lbs |
| 150 lbs | 60 lbs | 90 lbs | 130 lbs | 175 lbs | 220 lbs |
| 170 lbs | 70 lbs | 100 lbs | 145 lbs | 195 lbs | 245 lbs |
| 190 lbs | 75 lbs | 115 lbs | 160 lbs | 220 lbs | 275 lbs |
| 210 lbs | 85 lbs | 125 lbs | 180 lbs | 240 lbs | 305 lbs |
| 230 lbs | 90 lbs | 140 lbs | 195 lbs | 265 lbs | 335 lbs |
Women's barbell row standards by bodyweight#
Every cell is a one-rep max, rounded to the nearest 2.5 kg or 5 lbs. Find the row closest to your bodyweight and read across.
Average barbell row for women#
A woman at 65 kg (145 lbs) with a year or two of consistent training can expect a one-rep max around 40 kg (85 lbs) on the barbell row — the intermediate standard. A beginner at the same bodyweight starts near 17.5 kg (35 lbs), and an advanced lifter reaches about 52.5 kg (115 lbs).
In kilograms#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 50 kg | 12.5 kg | 20 kg | 30 kg | 40 kg | 52.5 kg |
| 55 kg | 15 kg | 22.5 kg | 32.5 kg | 45 kg | 57.5 kg |
| 60 kg | 15 kg | 25 kg | 35 kg | 47.5 kg | 62.5 kg |
| 70 kg | 17.5 kg | 27.5 kg | 42.5 kg | 55 kg | 72.5 kg |
| 80 kg | 20 kg | 32.5 kg | 47.5 kg | 65 kg | 85 kg |
| 90 kg | 22.5 kg | 35 kg | 55 kg | 72.5 kg | 95 kg |
In pounds#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 110 lbs | 30 lbs | 45 lbs | 65 lbs | 90 lbs | 115 lbs |
| 125 lbs | 30 lbs | 50 lbs | 75 lbs | 100 lbs | 130 lbs |
| 140 lbs | 35 lbs | 55 lbs | 85 lbs | 110 lbs | 145 lbs |
| 155 lbs | 40 lbs | 60 lbs | 95 lbs | 125 lbs | 165 lbs |
| 175 lbs | 45 lbs | 70 lbs | 105 lbs | 140 lbs | 185 lbs |
| 195 lbs | 50 lbs | 80 lbs | 115 lbs | 155 lbs | 205 lbs |
Barbell row standards by age#
Strength peaks in the mid-twenties to late thirties and tapers either side of it. Each row shows the intermediate standard for an 80 kg (175 lbs) man and a 65 kg (145 lbs) woman at that age, so a 16-year-old or a 55-year-old hitting these numbers is as far along as a 30-year-old hitting the main tables. Multiply any cell by the level ratios above to get the beginner or advanced number for your age.
| Age | Men (kg) | Men (lbs) | Women (kg) | Women (lbs) |
|---|---|---|---|---|
| 14–17 | 55 kg | 120 lbs | 30 kg | 70 lbs |
| 18–23 | 65 kg | 140 lbs | 37.5 kg | 85 lbs |
| 24–39 | 67.5 kg | 150 lbs | 40 kg | 85 lbs |
| 40–49 | 62.5 kg | 140 lbs | 37.5 kg | 80 lbs |
| 50–59 | 57.5 kg | 125 lbs | 32.5 kg | 75 lbs |
| 60+ | 50 kg | 110 lbs | 30 kg | 65 lbs |
How do you compare?#
A strict row usually lands at 80 to 90% of your bench press at the same level. If your row is far below that, your upper back is probably the gap, and it will start limiting your bench too. If your row is above your bench, check that the torso is not rising to help.
Pendlay rows, where the bar starts from the floor each rep with the torso parallel to it, usually move 10 to 20% less than bent-over rows, so they will place you a little lower on these tables — the Pendlay row vs bent-over row comparison explains why. Seal rows and chest-supported rows remove the lower back from the lift and move less. Yates-style rows with a more upright torso move more, but they work the lats over a shorter range.
Compared with the lat pulldown, the row usually sits a little lower at the same level. Training both vertical and horizontal pulling covers the whole back, and a big gap between them shows where you need more work.
How to test your one-rep max safely#
Testing a true row single invites cheating, because the heaviest reps always end up with your torso rising. Take a strict set of five to eight reps instead and run it through the one-rep max calculator for a reliable estimate.
Warm up with the warm-up calculator and use the plate calculator to load quickly between sets. Brace before each rep, keep the bar close to your legs, and let it settle to a dead stop if you are doing Pendlay rows.
Write down the variation and the torso angle with the number. A row at 45 degrees and a row closer to parallel with the floor are different lifts, and switching between them is the easiest way to fool yourself about progress.
How standards shift with bodyweight#
As with every lift, relative strength falls as bodyweight rises. A 60 kg lifter rowing bodyweight is doing something rarer than a 110 kg lifter rowing the same multiple.
The row also depends on how long you can hold the hinge position. Heavier lifters often have a more stable torso, which helps them row heavier, while lighter lifters tend to be limited by their lower back before their lats.
If your goal is pull-ups, your row and your bodyweight both matter. A strong row with extra body fat can still mean struggling with pull-ups, so track both numbers.
How to move up a level#
Add weight in small steps and keep the form strict. Three to five sets of five to eight reps, adding 2.5 kg whenever every rep reaches your torso without the hips helping, works well for novices. The progressive overload guide covers what to do when it stops working.
Pair rows with pressing. A 5x5 program or an upper lower split alternates rows with bench and overhead presses, which keeps your shoulders balanced and gives each lift time to recover.
Beyond intermediate, add variety rather than only adding weight. Chest-supported rows remove the lower back as a limit, paused rows build control at the top, and higher-rep dumbbell rows add volume without heavy loading on the spine.
Frequently asked questions#
How much should I be able to barbell row?
About 67.5 kg (150 lbs) for an 80 kg (175 lb) man after a year or two of consistent rowing — around 85% of bodyweight is the intermediate standard — and about 40 kg (85 lbs) for a 65 kg (145 lb) woman. Beginners usually start around four tenths of bodyweight for men and a quarter for women. The tables above give the exact number at your bodyweight for each level.
What is the average barbell row?
An untrained man rows roughly four tenths of his bodyweight with strict form and an untrained woman around a quarter of hers. Among people who train regularly, the average is around six tenths to 85% of bodyweight for men and four tenths to six tenths for women.
Should I be able to row what I bench?
Close to it. A strict row usually lands at 80 to 90% of your bench at the same level. Rowing more than you bench is possible but usually means the torso is rising to help; rowing far less points to an upper back that needs more work.
Is rowing your bodyweight good?
Yes. With strict form, a bodyweight row is just short of the advanced standard for men and above it for women. It means your upper back and lower back are strong enough to hold a hinge under heavy load.
What is the difference between a Pendlay row and a bent-over row?
A Pendlay row starts each rep from the floor with the torso parallel to it, while a bent-over row keeps the bar in the air with the torso at about 45 degrees. Most lifters bent-over row 10 to 20% more, because the higher torso and continuous tension help. These standards assume the bent-over row; if you Pendlay row, expect to sit a little lower and compare against your own Pendlay numbers over time.
Why does my lower back hurt after barbell rows?
Usually because the weight is heavy enough that your back starts rounding or you are standing up to finish the rep. Lower the weight, brace before each rep, and keep the torso angle fixed. If it still bothers you, chest-supported rows train the same muscles without loading the spine.
About the lift#
Barbell Bent Over Row — form, muscles worked, and common mistakes →