The lat pulldown is the back exercise almost every gym-goer does and almost nobody benchmarks. That makes the average lat pulldown weight hard to judge: is pulling your bodyweight good, normal, or rare? An untrained man pulls down around half his bodyweight; a year or two of steady back training usually brings that close to bodyweight.
The standards below assume a wide overhand grip to the upper chest on a cable stack, with your torso nearly upright and no swinging. They are written as multiples of bodyweight across five training levels, then converted into kilograms and pounds at common bodyweights using the weight shown on the stack.
Standards at a glance#
Each level is a one-rep max expressed as a multiple of bodyweight. Find your level in this table, then use the tables below it for the number at your weight.
| Level | Men (× bodyweight) | Women (× bodyweight) |
|---|---|---|
| Beginner | 0.5× | 0.35× |
| Novice | 0.7× | 0.5× |
| Intermediate | 0.95× | 0.7× |
| Advanced | 1.25× | 0.95× |
| Elite | 1.55× | 1.25× |
What each level means#
Beginner#
Around half your bodyweight for controlled reps, with the bar reaching your upper chest and your elbows driving down rather than back. Feeling your lats rather than your arms is the main goal at this stage.
Novice#
About seven tenths of bodyweight. A few months of training back twice a week gets most men here, and the weight goes up steadily as long as the reps stay strict and the torso stays still.
Intermediate#
Close to your own bodyweight. This is usually the stage where strict bodyweight pull-ups for several reps become possible, and progress on the stack slows to small weekly jumps.
Advanced#
One and a quarter times bodyweight, which empties the stack on many machines. At this point you will usually be doing weighted pull-ups as well, and the pulldown becomes a volume tool more than a test.
Elite#
One and a half times bodyweight or more, pulled strictly to the chest. Very few lifters reach this, and those who do usually have years of heavy rowing and weighted pull-ups behind them.
Men's lat pulldown standards by bodyweight#
Every cell is a one-rep max, rounded to the nearest 2.5 kg or 5 lbs. Find the row closest to your bodyweight and read across.
Average lat pulldown for men#
A man at 80 kg (175 lbs) with a year or two of consistent training can expect a one-rep max around 75 kg (165 lbs) on the lat pulldown — the intermediate standard. A beginner at the same bodyweight starts near 40 kg (90 lbs), and an advanced lifter reaches about 100 kg (220 lbs).
In kilograms#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 60 kg | 30 kg | 42.5 kg | 57.5 kg | 75 kg | 92.5 kg |
| 70 kg | 35 kg | 50 kg | 67.5 kg | 87.5 kg | 107.5 kg |
| 80 kg | 40 kg | 55 kg | 75 kg | 100 kg | 125 kg |
| 90 kg | 45 kg | 62.5 kg | 85 kg | 112.5 kg | 140 kg |
| 100 kg | 50 kg | 70 kg | 95 kg | 125 kg | 155 kg |
| 110 kg | 55 kg | 77.5 kg | 105 kg | 137.5 kg | 170 kg |
In pounds#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 130 lbs | 65 lbs | 90 lbs | 125 lbs | 165 lbs | 200 lbs |
| 150 lbs | 75 lbs | 105 lbs | 145 lbs | 190 lbs | 235 lbs |
| 170 lbs | 85 lbs | 120 lbs | 160 lbs | 215 lbs | 265 lbs |
| 190 lbs | 95 lbs | 135 lbs | 180 lbs | 240 lbs | 295 lbs |
| 210 lbs | 105 lbs | 145 lbs | 200 lbs | 265 lbs | 325 lbs |
| 230 lbs | 115 lbs | 160 lbs | 220 lbs | 290 lbs | 355 lbs |
Women's lat pulldown standards by bodyweight#
Every cell is a one-rep max, rounded to the nearest 2.5 kg or 5 lbs. Find the row closest to your bodyweight and read across.
Average lat pulldown for women#
A woman at 65 kg (145 lbs) with a year or two of consistent training can expect a one-rep max around 45 kg (100 lbs) on the lat pulldown — the intermediate standard. A beginner at the same bodyweight starts near 22.5 kg (50 lbs), and an advanced lifter reaches about 62.5 kg (140 lbs).
In kilograms#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 50 kg | 17.5 kg | 25 kg | 35 kg | 47.5 kg | 62.5 kg |
| 55 kg | 20 kg | 27.5 kg | 37.5 kg | 52.5 kg | 70 kg |
| 60 kg | 20 kg | 30 kg | 42.5 kg | 57.5 kg | 75 kg |
| 70 kg | 25 kg | 35 kg | 50 kg | 67.5 kg | 87.5 kg |
| 80 kg | 27.5 kg | 40 kg | 55 kg | 75 kg | 100 kg |
| 90 kg | 32.5 kg | 45 kg | 62.5 kg | 85 kg | 112.5 kg |
In pounds#
| Bodyweight | Beginner | Novice | Intermediate | Advanced | Elite |
|---|---|---|---|---|---|
| 110 lbs | 40 lbs | 55 lbs | 75 lbs | 105 lbs | 140 lbs |
| 125 lbs | 45 lbs | 65 lbs | 90 lbs | 120 lbs | 155 lbs |
| 140 lbs | 50 lbs | 70 lbs | 100 lbs | 135 lbs | 175 lbs |
| 155 lbs | 55 lbs | 80 lbs | 110 lbs | 145 lbs | 195 lbs |
| 175 lbs | 60 lbs | 90 lbs | 120 lbs | 165 lbs | 220 lbs |
| 195 lbs | 70 lbs | 100 lbs | 135 lbs | 185 lbs | 245 lbs |
Lat pulldown standards by age#
Strength peaks in the mid-twenties to late thirties and tapers either side of it. Each row shows the intermediate standard for an 80 kg (175 lbs) man and a 65 kg (145 lbs) woman at that age, so a 16-year-old or a 55-year-old hitting these numbers is as far along as a 30-year-old hitting the main tables. Multiply any cell by the level ratios above to get the beginner or advanced number for your age.
| Age | Men (kg) | Men (lbs) | Women (kg) | Women (lbs) |
|---|---|---|---|---|
| 14–17 | 60 kg | 135 lbs | 37.5 kg | 80 lbs |
| 18–23 | 72.5 kg | 160 lbs | 42.5 kg | 95 lbs |
| 24–39 | 75 kg | 165 lbs | 45 kg | 100 lbs |
| 40–49 | 70 kg | 155 lbs | 42.5 kg | 95 lbs |
| 50–59 | 65 kg | 140 lbs | 37.5 kg | 85 lbs |
| 60+ | 57.5 kg | 125 lbs | 35 kg | 75 lbs |
How do you compare?#
Cable machines vary more than most people realise. Stacks are labelled in different units, pulleys change the effective load, and two machines in the same gym can feel 10 to 20% apart at the same pin. Use these standards as a guide, and track your own progress on one machine.
The pulldown and the pull-up train the same muscles, but they are not the same number, because the pull-up adds the work of stabilising your whole body. A pulldown of around 80% of bodyweight for eight clean reps — a one-rep max close to bodyweight — usually predicts a first strict pull-up. The lat pulldown vs pull-up comparison covers how to program both.
Compared with rowing, the pulldown usually lands a little above a strict barbell row at the same level. If your pulldown is far ahead of your row, your mid-back is probably the gap; if your row is far ahead, your lats or grip may be holding the pulldown back.
How to test your one-rep max safely#
Pulldowns are a poor lift to test with a single. Instead, take a strict set of six to ten reps with a rep or two left in reserve and run it through the one-rep max calculator. The estimate is reliable in that range and avoids the swinging and leaning back that a maximal attempt invites.
Keep every rep strict. The bar reaches your upper chest, your torso stays within about fifteen degrees of upright, and your feet stay under the pad. Leaning back turns the pulldown into a row and lets you move much more weight, but the extra weight comes from momentum and posture rather than from your lats.
Grip changes the number too. Close neutral grips usually allow a few kilos more than a wide overhand grip, and underhand grips bring more biceps into the lift. Log the grip with the weight so your comparisons stay honest.
How standards shift with bodyweight#
Relative pulling strength falls as bodyweight rises. A 60 kg lifter pulling down one and a quarter times bodyweight is doing something harder than a 110 kg lifter pulling the same multiple, and the gap widens on pull-ups, where you have to move your whole body.
This is why lighter lifters often find pull-ups easy and heavy lifters often find them hard, even when their pulldown numbers look similar. The pulldown lets heavier lifters train the same muscles with a load they can control, which is exactly why it is useful.
Losing body fat improves your pull-up much faster than your pulldown, because the pull-up gets lighter while the stack does not. If your goal is pull-ups, track both numbers.
How to move up a level#
Use a rep range rather than chasing heavier weights every week. Three sets of eight to twelve, adding reps until you hit the top of the range, then moving the pin one plate down is a simple pattern that works for a long time. The progressive overload guide covers what to do when it stops working.
Train back with enough volume. Most lifters need 10 to 20 hard sets per week for the back, split between vertical pulls like pulldowns and horizontal pulls like rows. The sets per muscle guide explains how to count them, and a push pull legs split makes room for both.
Once the stack starts running out, move toward pull-ups and weighted pull-ups as the main lift, and keep the pulldown for higher-rep work. Single-arm pulldowns and pauses at the bottom help when one side lags or the lats stop doing the work.
Frequently asked questions#
How much should I be able to lat pulldown?
About 75 kg (165 lbs) for an 80 kg (175 lb) man with a year or two of consistent back training — close to bodyweight is the intermediate standard — and about 45 kg (100 lbs) for a 65 kg (145 lb) woman. Beginners usually start around half their bodyweight. The tables above give the exact number at your bodyweight for each level.
What is the average lat pulldown weight?
An untrained man pulls down roughly half his bodyweight and an untrained woman around a third of hers. Among people who train regularly, the average is about seven tenths of bodyweight to bodyweight for men, and half to seven tenths for women.
Is pulling down your bodyweight good?
Yes. For a man it is just above the intermediate standard; for a woman it is an advanced number. Either way it means your lats are strong enough that strict pull-ups should be well within reach.
How much should I lat pulldown before I can do a pull-up?
Most people manage their first strict pull-up once they can pull down around 80% of their bodyweight for eight clean reps, which works out to a one-rep max close to bodyweight. Some get there sooner and some later, depending on body proportions, grip strength, and how much body fat they carry.
Why does the same weight feel different on different machines?
Because cable machines use different pulleys, cables, and stack labels. Some double the effective load through the pulley system, some halve it, and friction varies with maintenance. The number on the pin is only comparable on the same machine, which is why your own log matters more than these tables.
Should I lean back on lat pulldowns?
A slight lean of up to about fifteen degrees is normal and lets the bar clear your face. Leaning back much further turns the movement into a row and lets you move more weight with less lat work. For these standards, and for building your lats, keep the torso close to upright.